SIMULATION - Guidelines - This is a lab item in which tasks will be performed on virtual devices: • Refer to the Ta…

SIMULATION - Guidelines - This is a lab item in which tasks will be performed on virtual devices: • Refer to the Tasks tab to view the tasks for this lab item. • Refer to the Topology tab to access the device console(s) and perform the tasks. • Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window. • All necessary pre-configurations have been applied. • Do not remove any existing configurations from the devices, only those necessary to make the appropriate changes required to fulfill the listed tasks. • Do not change the enable password or hostname for any device. • Save your configurations to NVRAM before moving to the next item. • Click Next at the bottom of the screen to submit this lab and move to the next question. • When Next is clicked, the lab closes and cannot be reopened. Topology - //IMG// Tasks - Reference Topology Diagram and table. Configure IPv4 and IPv6 between the two routers. Task 1: • Configure R1 with the first usable host IP address in the IPv4 network. • Configure R2 with the last usable host IP address in the IPv4 network. • Verify connectivity using ping. Task 2: • Do not assign the subnet router anycast address to either router. • Configure R1 with the first usable host IP address in the IPv6 network. • Configure R2 with the last usable host IP address in the IPv6 network. • Verify connectivity using ping.