# 200-301 — Question 1714

**Type:** case_study
**Topics:** network_config, ipv4, ipv6, connectivity

## Question

SIMULATION
-


Guidelines
-

This is a lab item in which tasks will be performed on virtual devices:

• Refer to the Tasks tab to view the tasks for this lab item.
• Refer to the Topology tab to access the device console(s) and perform the tasks.
• Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
• All necessary pre-configurations have been applied.
• Do not remove any existing configurations from the devices, only those necessary to make the appropriate changes required to fulfill the listed tasks.
• Do not change the enable password or hostname for any device.
• Save your configurations to NVRAM before moving to the next item.
• Click Next at the bottom of the screen to submit this lab and move to the next question.
• When Next is clicked, the lab closes and cannot be reopened.


Topology
-

//IMG//



Tasks
-

Reference Topology Diagram and table. Configure IPv4 and IPv6 between the two routers.

Task 1:

• Configure R1 with the first usable host IP address in the IPv4 network.
• Configure R2 with the last usable host IP address in the IPv4 network.
• Verify connectivity using ping.

Task 2:

• Do not assign the subnet router anycast address to either router.
• Configure R1 with the first usable host IP address in the IPv6 network.
• Configure R2 with the last usable host IP address in the IPv6 network.
• Verify connectivity using ping.

## Correct Answer

_See scenario._

**Reference:** examtopics_top_comment

---
Source: https://hiexam.net/q/cisco/200-301/1714  
Practice (tracked): https://hiexam.net/study/200-301/practice