SIMULATION
-
//IMG//
R1 has been pre-configured with all the necessary commands. All physical cabling is in place and verified. Connectivity to the end devices must be configured.
1. Configure SW-1 switch port 0/1 to carry traffic for the Cisco IP phone and PC
2. Configure SW-2 E0/1 to carry traffic for PC2
3. Configure VLAN 10 with the name “Engineering” on SW-1
4. Configure the link between SW-1 and SW-2 to use the vendor neutral neighbor discovery protocol
5. Configure the link on SW-1 to R1 so that it does not allow the Cisco neighbor discovery protocol to pass
Case study scenario
R1 has been pre-configured with all the necessary commands. All physical cabling is in place and verified. Connectivity to the end devices must be configured.
1. Configure SW-1 switch port 0/1 to carry traffic for the Cisco IP phone and PC
2. Configure SW-2 E0/1 to carry traffic for PC2
3. Configure VLAN 10 with the name “Engineering” on SW-1
4. Configure the link between SW-1 and SW-2 to use the vendor neutral neighbor discovery protocol
5. Configure the link on SW-1 to R1 so that it does not allow the Cisco neighbor discovery protocol to pass