SIMULATION - Guidelines - This is a lab item in which tasks will be performed on virtual devices. • Refer to the Ta…

SIMULATION - Guidelines - This is a lab item in which tasks will be performed on virtual devices. • Refer to the Tasks tab to view the tasks for this lab item. • Refer to the Topology lab to access the device console(s) and perform the tasks. • Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window. • All necessary preconfigurations have been applied. • Do not change the enable password or hostname for any device. • Save your configurations to NVRAM before moving to the next item. • Click Next at the bottom of the screen to submit this lab and move to the next question. • When Next is clicked, the lab closes and cannot be reopened. Topology - //IMG// Tasks - All physical cabling is in place and verified. Router R1 is configured and passing traffic for VLANs 5 and 6. All relevant ports are pre-configured as 802.1q trunks. 1. Configure SW-1 port E0/0 to permit only VLANS 5 and 6 2. Configure both SW-1 and SW-2's E0/1 ports to send and receive untagged traffic over VLAN 77 3. Configure SW-2 E0/2 port to permit only VLAN 6 4. Configure both SW-3 and SW-4 ports e0/0 and e0/1 for link aggregation using the industry standard protocol with the following requirements: o SW-3 ports must immediately negotiate the aggregation protocol o SW-4 ports must not initiate the negotiation for the aggregation protocol o Use the designated number assignment