# 200-301 — Question 1696

**Type:** case_study
**Topics:** network_configuration, vlan_management, link_aggregation

## Question

SIMULATION
-


Guidelines
-

This is a lab item in which tasks will be performed on virtual devices.

• Refer to the Tasks tab to view the tasks for this lab item.
• Refer to the Topology lab to access the device console(s) and perform the tasks.
• Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
• All necessary preconfigurations have been applied.
• Do not change the enable password or hostname for any device.
• Save your configurations to NVRAM before moving to the next item.
• Click Next at the bottom of the screen to submit this lab and move to the next question.
• When Next is clicked, the lab closes and cannot be reopened.


Topology
-

//IMG//



Tasks
-
All physical cabling is in place and verified. Router R1 is configured and passing traffic for VLANs 5 and 6. All relevant ports are pre-configured as 802.1q trunks.

1. Configure SW-1 port E0/0 to permit only VLANS 5 and 6
2. Configure both SW-1 and SW-2's E0/1 ports to send and receive untagged traffic over VLAN 77
3. Configure SW-2 E0/2 port to permit only VLAN 6
4. Configure both SW-3 and SW-4 ports e0/0 and e0/1 for link aggregation using the industry standard protocol with the following requirements:

o SW-3 ports must immediately negotiate the aggregation protocol
o SW-4 ports must not initiate the negotiation for the aggregation protocol
o Use the designated number assignment

## Correct Answer

_See scenario._

**Reference:** examtopics_top_comment

---
Source: https://hiexam.net/q/cisco/200-301/1696  
Practice (tracked): https://hiexam.net/study/200-301/practice