SIMULATION - Guidelines - This is a lab item in which tasks will be performed on virtual devices. • Refer to the Ta…

SIMULATION - Guidelines - This is a lab item in which tasks will be performed on virtual devices. • Refer to the Tasks tab to view the tasks for this lab item. • Refer to the Topology tab to access the device console(s) and perform the tasks. • Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window. • All necessary preconfigurations have been applied. • Do not change the enable password or hostname for any device. • Save your configurations to NVRAM before moving to the next item. • Click Next at the bottom of the screen to submit this lab and move to the next question. • When Next is clicked, the lab doses and cannot be reopened. Topology - //IMG// Tasks - All physical cabling is in place and verified. Switch SW-1 is pre-configured and inaccessible. SW-2 and SW-3 ports must be configured and operational to complete the configuration. 1. Configure SW-2 and SW-3 ports E0/0 to use the industry standard encapsulation method for trunking and only tag VLAN 10 2. Configure SW-2 and SW-3 ports E0/0 to send and receive untagged traffic over VLAN 11 3. Configure SW-2 and SW-3 ports E0/2 and E0/3 to use the industry standard encapsulation method for trunking and tag all VLANS 4. Configure SW-2 and SW-3 ports E0/2 and E0/3 for link aggregation using the industry standard protocol with the following requirements: o SW-2 ports must not initiate the negotiation for the aggregation protocol o SW-3 ports must immediately negotiate the aggregation protocol o Use the designated number assignment