# 200-301 — Question 1688

**Type:** case_study
**Topics:** switch_configuration, network_trunking, link_aggregation

## Question

SIMULATION
-


Guidelines
-

This is a lab item in which tasks will be performed on virtual devices.

• Refer to the Tasks tab to view the tasks for this lab item.
• Refer to the Topology tab to access the device console(s) and perform the tasks.
• Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
• All necessary preconfigurations have been applied.
• Do not change the enable password or hostname for any device.
• Save your configurations to NVRAM before moving to the next item.
• Click Next at the bottom of the screen to submit this lab and move to the next question.
• When Next is clicked, the lab doses and cannot be reopened.


Topology
-

//IMG//



Tasks
-

All physical cabling is in place and verified. Switch SW-1 is pre-configured and inaccessible. SW-2 and SW-3 ports must be configured and operational to complete the configuration.

1. Configure SW-2 and SW-3 ports E0/0 to use the industry standard encapsulation method for trunking and only tag VLAN 10
2. Configure SW-2 and SW-3 ports E0/0 to send and receive untagged traffic over VLAN 11
3. Configure SW-2 and SW-3 ports E0/2 and E0/3 to use the industry standard encapsulation method for trunking and tag all VLANS
4. Configure SW-2 and SW-3 ports E0/2 and E0/3 for link aggregation using the industry standard protocol with the following requirements:
o SW-2 ports must not initiate the negotiation for the aggregation protocol
o SW-3 ports must immediately negotiate the aggregation protocol
o Use the designated number assignment

## Correct Answer

_See scenario._

**Reference:** examtopics_top_comment

---
Source: https://hiexam.net/q/cisco/200-301/1688  
Practice (tracked): https://hiexam.net/study/200-301/practice